8 in. SmoothGrip Wheel

This is a 2010 FIRST Wheel, provided in the FRC Kit of Parts. No bearings are included.





Usage:

Use #10-24x3/4 thread forming screws to attach sprockets or hubs to this wheel. Three (3) screws are sufficient for each wheel.



With Axle and Hub : If you wish to drive this wheel with an Axle and Hub, you can pick your hub by fitting any of the AndyMark hubs to this wheel. Hubs are NOT included in the price of the wheel. If this is your choice, then no bearing is needed. To install a hub onto a 6" FIRST Wheel, use #10-24x3/4 thread forming screws. With Sprocket : If you wish to drive this wheel with a sprocket, then the sprocket needs to be attached to the side of the wheel, and one ball bearing needs to be pressed into the wheel (on one side). The ball bearing must have a 1.125" od. For a 1/2" id, use am-0029. For a 3/8" id, use am-0209. Use #10-24x3/4 thread forming screws With Bearings : To press bearings into this wheel (for a free spinning wheel or for use with a sprocket), two ball bearings need to be pressed into the wheel (one on each side). The ball bearing must have a 1.125" od. For a 1/2" id, use am-0029. For a 3/8" id, use am-0209.